Skip to main content

Add Outbound Bridge

Configure the web URL, login details, number and bridge information needed in order to place an outbound DDI call from your web based conference.

Note: In order to complete this task you will need to have at least one number entered in the Numbers module under the number type Outbound Conference Quality. If you do not have any numbers entered, the Bridge drop-down menu in Step 2a will be empty.

To add an outbound bridge, do the following:

  1. Navigate to the Add Outbound Bridge dialog box as illustrated below.
    Figure 1. Illustration of the Navigation to the 'Add Outbound Bridge' dialog box

    1. Navigate to the Outbound Bridge module here (this is nested in a tab which can be located along the top of the page under the Numbers module).
    2. Click the + Add (this is located top right of the screen).
  2. In the Add Outbound Bridge dialog box, fill out the required fields as listed below.
    Figure 2. The 'Add Outbound Bridge' dialog box

    1. Bridge: The bridge you select will determine the numbers that are available in the DDI Number drop-down in the next step. Only numbers that have been assigned to the chosen bridge will be shown.
    2. DDI Number: From the drop-down list, choose the dial-in number that will be used to dial inbound to the conference bridge.
    3. Region: Choose the region to assign to your bridge from the drop-down.
    4. Url: (Web-based Conference ONLY) Enter the URL address of the web-based conference.
    5. Username: (Web-based Conference ONLY) Enter the login user name needed for the web-based conference.
    6. Password:(Web-based Conference ONLY) Enter the password details for the web-based conference.
    7. Add: Click the Add
  3. Your task is complete.
Results: The page will refresh and the outbound bridge you have created will be shown at the top of the list.

Was this article helpful?

0 out of 0 found this helpful