Welcome to the Spearline Knowledge Center

Use batch tests to run a set of connection tests in quick succession to determine a number's connectivity rate.

Note: Batch tests can be performed from any place where you can see numbers that have the Batch Test icon highlighted in the Actions column. If the icon is not highlighted this means that running batch tests is not an option.

Note: To perform batch testing on several numbers at once you can use Bulk Actions.

• Bulk Actions

To perform a batch test, do the following:

1. Use the search bar or the filters provided if necessary to search for the number you wish to batch test.
2. Click the Batch Test Icon to reveal the test setup dialog box (the icon is located in the Actions column on the right of the table)
3. Choose the amount of tests you would like to perform on the number followed by the amount of time (offset) you would like to pass between each test.
   
   
   
   
   Note: Offset time is measured in minutes.
4. Click Save and you will then receive a confirmation on-screen that the tests have been scheduled to run.
   
   
   
   
5. You have completed the task.